| Product description |
|
The TE210P supports E1, T1, and J1 environments and is selectable on a per-card or per-port basis. This feature enables signaling translation between E1, T1, J1 equipment and allows inexpensive T1 channel banks to connect with E1 circuits. Because the TE210P improves I/O speed by up to 10 times, the result is reduced CPU usage and increased card density per server.
The TE210P supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported, also included are advanced call features.
The TE210P supports a 3.3v PCI slot only - typically available on newer motherboards and in 64-bit PCI bus architectures. The TE205P is for use only with a 5.0 volt PCI slot.
Data Modes
Cicso HDLC
HDLC
PPP
Multilink PPP
Frame Relay
Voice Modes
PRI CPE & PRI NET
NI1
NI2
EuroISDN
4ESS (AT&T)
5ESS (Lucent)
DMS100
E&M
Wink
Feature Group B
Feature Group D
FXO & FXS
Ground Start
Loop Start
Loop Start with Disconnect Detect
Certifications
Telecom
FCC Part 68 (TIA-968-A), IC CS-03, TBR 4, TBR 12, TBR 13, AS/ACIF S038, AS/ACIF S016
Safety
UL/CSA 60950, IEC 60950, EN60950, AS/NZS 60950
Note: Finland, Norway and Sweden require that equipment using this product must be located in a Restricted Access Location (RAL).
Emissions
EN55022 Class B Radiated & Conducted
Immunity
EN55024 ITE, EN61000 |
|
